Recommended doses are in the range 4-8 ml/kg, and an infusion rate of 60 ml/kg/hour should not be exceeded.

Hypertonic saline (7.2 % w/v) should be used in conjunction with conventional fluid therapy. The administration of hypertonic saline is usually followed by the intravenous administration of an isotonic intravenous fluid (e.g. an intravenous 0.9 % Sodium Chloride solution).

Adequate access to drinking water should also be provided.

VISUAL INSPECTION

1. Ensure that the solution is clear and free from particles, and that the container is undamaged (check for leaks). If you regard the integrity of the pack as suspect, discard solution.

2. Read all precautionary notes (label and package leaflet) and check the expiry date before use.

PACK PREPARATION

1. Warm the pack to approximately 37°C.

2. Remove the pack from the protective overwrap by tearing downwards from the serrated edge.

3. Carefully straighten hanger and ports if necessary.

4. Remove the port plug protecting the sterile giving port. Do this by twisting off the top section while holding the bottom section.

5. Insert the administration set fully to produce a leak-proof connection and suspend the bag from an infusion stand.

6. An air inlet is not required.

7. Prime and regulate the administration set in accordance with the manufacturer’s instructions. If the administration set becomes blocked, do not pump solution back into the pack, replace equipment.

AFTER USE

1. The solution does not contain an antimicrobial preservative and is intended for single use only. Discard any unused solution.

2. Dispose of any unused product and empty containers in accordance with guidance from your local waste regulation authority.